Flexispot Standing Desk Review …Flexispot Desktop…
Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are very little, here are a few features that I wasn’t necessarily a substantial fan of:
The package that the desk came in was heavy, so bringing it inside was a group effort, however this is just a consequence of how sturdy the Flexispot is.
The hassle-free cable tray was a bit complicated to set up. In the end, you ultimately slip it under screws, which wasn’t extremely clear from the directions.
You will require to buy an anti-fatigue mat to remain comfortable, however this is a great concept for any standing desks, so I can’t fault Flexispot for that.
When it got here and I saw how heavy it was, I was both excited (given that this implied it was going to be tough) and likewise a little hesitant (due to the fact that we all understand just how much of an obstacle assembling furnishings can be).
Thankfully, with the help of an instructional YouTube link, it took me just around 42 minutes to put together. Scratch that, it took my 11-year-old daughter, with some supervision from me, from start to finish. The only problem I have with assembly was the cable tray, which I discovered wasn’t described well in the guidelines.
Once assembled, I love the sleek appearance of this desk. I’m confident any of the many diverse surfaces that it comes in would look great in any office, and the adjustable width makes it easy to fit it in even the tiniest of office.
The peaceful operation and height memory settings make it simple, efficient, and peaceful to switch in between sitting and standing as many times as you want throughout the day.
This desk is strong. It can hold up to 335 lbs even while in operation, so if you have a hefty home computer (or want to sleep on it for some reason) it has you covered. It will likewise uniformly disperse weight no matter how out of balance the weight you place on it is, it won’t wobble or wiggle.
because video is pretty kitted out as the desk we’re taking a look at today is pretty basic I attempted to get as near that as I might on uplifts site with equivalent configurations the flexi spot desk we’re taking a look at today will run you about four hundred and 10 dollars versus 6 hundred and fifty for a comparable desk from uplift I attempt to get as close as possible with the uplift design is really 5 inches longer but you can do a lot with 5 inches boom yes now for transparency flexi spot did send this desk out for review however as you should know by now does not impact my review in any way the desktop here is 55 inches wide 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not shipping up until completion of April at the earliest the desktop is an inch thick however it’s this standard laminate as you can perhaps get doing not have even any cable television grommets for travel through the outdoors carton
for the desktop was not harmed in any way which is entirely bizarre due to the fact that I could shoot a 30-second b-roll montage of simply the damage and flaws on this desktop scuffed scraped pitted simply very rough male if I had purchased this I ‘d have been on the phone with customer care right away they did likewise handled to miss drilling the pilot holes where you can attach the control box to the desktop a great deal of needing to do that myself without mistakenly drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was in fact quite uncomplicated the entire thing came together in about 45 minutes and despite the fact that there’s cable televisions running to it from each element to support motorized function strangely absolutely where any kind of cable management materials whatsoever the frame on this system is a single motor dual phase design versus the dual motor three-stage design that comes requirement with the uplift desk this can be upgraded too to both the double phase dual motor and a three-stage double motor which presses the cost of the desk up
an additional 70 bucks the frame is designed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can range from just under 28 inches to simply over forty seven point six inches so a max I ‘d it is more than high adequate even for me and I stay at 6 foot for this model does come standard with the control panel that allows for up-and-down movement plus 3 memory areas with an LED readout to tell you the desk height the single motor design uses this drive shaft assembly which has to be changed as the width of the desk is adjusted the motor operation itself while it might be sluggish is very peaceful as in barely audible this outside a rate would be the one benefit I would provide this unit over the uplift desk and I wish to beware here since this isn’t a hit piece this desk is 240 dollars more affordable than the similar uplift model over 35% cheaper even if you update this flexi area test to the double motor three-stage design it still is available in a hundred and seventy dollars less expensive than the uplift but less expensive does not suggest low-cost this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is strong even if max height I’ll certainly provide it that but the lateral stability of this desk the horizontal motion at this rate point it’s undesirable it’s add fuel to the fire here they include a little safety baffle this little steel piece that installs to the frame and covers a portion of this turning driveshaft when
this desk sees any lateral motion at all the drive shaft strikes this baffle and the noise is definitely shocking to top things off I decided to include rolling casters to this desk this was a $30 upgrade and two of those 4 casters got here harmed too my plan for this desk at this point is to lose the desk top and featured completely and change it with a white laminate lemon table from Ikea and use it as an adjustable photo table which you can’t do this frame will accommodate desktops approximately 63 inches large and 31 and a half inches deep so this will roll around the studio make it much easier to film items without having to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift first that is a financial investment in quality workplace furniture that will last you this at best feels like a less expensive replica of that it just does not feel quality and the difference in between this desk and my primary desk is night and day do feel free to take a look at their site too which likewise feels eerily similar to one of their competitors there’s a wealth of accessories you can get for the flexi area desk as much as and including a foot massager and even a fixed exercise bike and I might spend another 10 minutes of our valuable time covering different options and accessories I might however I believe I’m better that they only sent a basic desk since as a fundamental desk I’m not a fan of the quality assurance at this price point and I don’t think slapping on a bunch of bonus is the move when the core item isn’t what it must be they do offer a 30-day trial if you’re just morbidly curious and they service warranty their desks for three years really desk is five years and uplift desk is seven years if you are Flexispot Desktop
in the market for a sit-stand desk they’re remarkable mine’s been a life changer for me both in regards to gaming and performance however I would spend the money it’s gon na take to enter a greater end maker like uplift desk or extremely desk and I haven’t personally used extremely desk items so I can’t speak on it but their credibility is excellent huge thanks to flexi area for sending this out for evaluation regrettably I can not recommend this unit and for the record I’m a hundred percent sure they would have gladly changed the parts that I had a concern with seeing as how both the desktop and the casters showed up harmed however from a client standpoint you ‘d probably be actually delighted to get this in