Flexispot Standing Desk Review …Flexispot Ep4 Electric Standing Desk 63 X30…
Cons: What I Didn’t Like About the Flexispot E7
Though the cons on this desk are very little, here are a couple of functions that I wasn’t always a huge fan of:
The plan that the desk was available in was heavy, so bringing it inside was a group effort, but this is simply a repercussion of how durable the Flexispot is.
The practical cable television tray was a bit complicated to set up. In the end, you eventually slip it under screws, which wasn’t extremely clear from the directions.
You will need to buy an anti-fatigue mat to stay comfy, however this is a great concept for any standing desks, so I can’t fault Flexispot for that.
When it showed up and I saw how heavy it was, I was both excited (given that this meant it was going to be strong) and likewise a little hesitant (since all of us understand just how much of a challenge assembling furniture can be).
Luckily, with the help of an instructional YouTube link, it took me only around 42 minutes to put together. Scratch that, it took my 11-year-old child, with some supervision from me, from start to finish. The only problem I have with assembly was the cable television tray, which I found wasn’t explained well in the instructions.
Once assembled, I love the smooth look of this desk. I’m confident any of the many varied finishes that it is available in would look fantastic in any workplace, and the adjustable width makes it easy to fit it in even the tiniest of office.
The peaceful operation and height memory settings make it easy, efficient, and peaceful to change in between sitting and standing as sometimes as you want throughout the day.
This desk is strong. It can hold up to 335 pounds even while in operation, so if you have a substantial desktop (or want to sleep on it for some reason) it has you covered. It will likewise uniformly distribute weight no matter how out of balance the weight you put on it is, it won’t wiggle or wobble.
in that video is quite kitted out as the desk we’re looking at today is pretty fundamental I tried to get as near that as I might on uplifts website with similar configurations the flexi spot desk we’re looking at today will run you about four hundred and ten dollars versus 6 hundred and fifty for a similar desk from uplift I try to get as close as possible with the uplift model is in fact 5 inches longer but you can do a lot with 5 inches boom yes now for transparency flexi spot did send this desk out for evaluation however as you need to understand by now does not impact my evaluation in any way the desktop here is 55 inches large 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not shipping until completion of April at the earliest the desktop is an inch thick however it’s this basic laminate as you can potentially get doing not have even any cable television grommets for go through the outdoors carton
for the desktop was not damaged in any way which is absolutely unusual due to the fact that I could shoot a 30-second b-roll montage of simply the damage and defects on this desktop scuffed scraped pitted just incredibly rough guy if I had bought this I ‘d have been on the phone with customer care instantly they did likewise handled to miss drilling the pilot holes where you can connect the control box to the desktop a great deal of needing to do that myself without unintentionally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was really pretty straightforward the whole thing came together in about 45 minutes and despite the fact that there’s cables going to it from each component to support motorized function unusually definitely where any sort of cable television management materials whatsoever the frame on this unit is a single motor double phase design versus the dual motor three-stage design that comes requirement with the uplift desk this can be updated as well to both the double phase double motor and a three-stage double motor which pushes the cost of the desk up
an extra 70 dollars the frame is created for a max load of 154 pounds and it moves at a rate at an inch per second the height can vary from just under 28 inches to just over forty seven point six inches so a max I ‘d it is more than tall sufficient even for me and I stay at 6 foot for this model does come basic with the control panel that allows for up-and-down movement plus 3 memory areas with an LED readout to inform you the desk height the single motor design uses this drive shaft assembly which has to be changed as the width of the desk is adjusted the motor operation itself while it might be sluggish is very peaceful as in barely audible this outside a price would be the one benefit I would give this system over the uplift desk and I want to be careful here since this isn’t a hit piece this desk is 240 dollars less expensive than the similar uplift design over 35% more affordable even if you update this flexi spot test to the double motor three-stage style it still comes in a hundred and seventy dollars cheaper than the uplift but less expensive does not indicate cheap this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is solid even if max height I’ll certainly provide it that however the lateral stability of this desk the horizontal motion at this rate point it’s unacceptable it’s add fuel to the fire here they include a little safety baffle this little steel piece that mounts to the frame and covers a part of this turning driveshaft when
this desk sees any lateral movement at all the drive shaft hits this baffle and the sound is absolutely frustrating to leading things off I decided to include rolling casters to this desk this was a $30 upgrade and two of those 4 casters arrived harmed as well my plan for this desk at this moment is to lose the desk top and featured all together and replace it with a white laminate lemon table from Ikea and use it as an adjustable image table which you can’t do this frame will accommodate desktops up to 63 inches broad and 31 and a half inches deep so this will roll around the studio make it simpler to movie products without needing to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift first that is a financial investment in quality workplace furnishings that will last you this at finest feels like a cheaper imitation of that it simply doesn’t feel quality and the distinction between this desk and my main desk is night and day do feel free to take a look at their website too which also feels eerily similar to one of their competitors there’s a wealth of devices you can get for the flexi area desk approximately and including a foot massager and even a fixed stationary bicycle and I could invest another 10 minutes of our precious time covering various choices and devices I might but I think I’m better that they only sent out a basic desk because as a fundamental desk I’m not a fan of the quality control at this rate point and I don’t think slapping on a bunch of extras is the move when the core product isn’t what it must be they do use a 30-day trial if you’re simply morbidly curious and they warranty their desks for three years very desk is five years and uplift desk is 7 years if you are Flexispot Ep4 Electric Standing Desk 63 X30
in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in terms of gaming and productivity but I would spend the additional money it’s gon na require to enter a greater end maker like uplift desk or very desk and I have not personally utilized very desk products so I can’t speak on it however their credibility is very good huge thanks to flexi area for sending this out for evaluation sadly I can not recommend this system and for the record I’m a hundred percent sure they would have gladly replaced the parts that I had a problem with viewing as how both the desktop and the casters arrived damaged however from a consumer viewpoint you ‘d most likely be truly excited to get this in