Flexispot Standing Desk Review …Flexispot Standing Desk Pro Review…
Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are very little, here are a couple of functions that I wasn’t always a huge fan of:
The package that the desk can be found in was heavy, so bringing it inside was a group effort, but this is simply a repercussion of how strong the Flexispot is.
The practical cable television tray was a bit complicated to set up. In the end, you eventually slip it under screws, which wasn’t very clear from the instructions.
You will require to purchase an anti-fatigue mat to stay comfy, however this is a good idea for any standing desks, so I can’t fault Flexispot for that.
When it showed up and I saw how heavy it was, I was both excited (because this implied it was going to be sturdy) and likewise a little hesitant (because all of us understand just how much of a challenge putting together furnishings can be).
Fortunately, with the help of a training YouTube link, it took me just around 42 minutes to put together. Scratch that, it took my 11-year-old daughter, with some guidance from me, from start to finish. The only problem I have with assembly was the cable tray, which I discovered wasn’t explained well in the directions.
As soon as assembled, I enjoy the streamlined look of this desk. I’m confident any of the many diverse finishes that it is available in would look excellent in any workplace, and the adjustable width makes it simple to fit it in even the tiniest of home offices.
The quiet operation and height memory settings make it simple, efficient, and quiet to change in between sitting and standing as often times as you desire throughout the day.
Lastly, this desk is sturdy. It can hold up to 335 lbs even while in operation, so if you have a large home computer (or want to take a nap on it for some reason) it has you covered. It will also equally distribute weight no matter how out of balance the weight you place on it is, it won’t wobble or wiggle.
because video is pretty kitted out as the desk we’re taking a look at today is quite standard I tried to get as near to that as I might on uplifts website with equivalent configurations the flexi spot desk we’re taking a look at today will run you about four hundred and 10 dollars versus six hundred and fifty for a comparable desk from uplift I attempt to get as close as possible with the uplift model is in fact 5 inches longer but you can do a lot with 5 inches boom yes now for openness flexi area did send this desk out for evaluation but as you ought to know by now doesn’t affect my evaluation in any way the desktop here is 55 inches wide 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming but it’s not shipping till the end of April at the earliest the desktop is an inch thick however it’s this fundamental laminate as you can possibly get doing not have even any cable grommets for travel through the outdoors container
for the desktop was not harmed in any way which is utterly strange due to the fact that I could shoot a 30-second b-roll montage of just the damage and defects on this desktop scuffed scraped pitted simply extremely rough man if I had actually bought this I ‘d have been on the phone with customer service immediately they did also managed to miss drilling the pilot holes where you can attach the control box to the desktop a lot of needing to do that myself without inadvertently drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from having to drill that top was in fact pretty simple the whole thing came together in about 45 minutes and despite the fact that there’s cables going to it from each component to support motorized function oddly definitely where any kind of cable management products whatsoever the frame on this unit is a single motor dual stage design versus the dual motor three-stage design that comes standard with the uplift desk this can be updated also to both the double stage dual motor and a three-stage double motor which presses the cost of the desk up
an additional 70 bucks the frame is designed for a max load of 154 pounds and it moves at a rate at an inch per 2nd the height can range from simply under 28 inches to just over forty 7 point six inches so a max I ‘d it is more than tall enough even for me and I stay at 6 foot for this model does come basic with the control panel that enables up-and-down motion plus 3 memory areas with an LED readout to inform you the desk height the single motor style utilizes this drive shaft assembly which needs to be adjusted as the width of the desk is adjusted the motor operation itself while it might be sluggish is really quiet as in barely audible this outside a cost would be the one advantage I would offer this unit over the uplift desk and I wish to beware here because this isn’t a hit piece this desk is 240 dollars less expensive than the similar uplift model over 35% less expensive even if you upgrade this flexi area test to the double motor three-stage style it still can be found in a hundred and seventy dollars cheaper than the uplift however cheaper does not suggest low-cost this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is strong even if max height I’ll certainly provide it that however the lateral stability of this desk the horizontal movement at this rate point it’s undesirable it’s rub salt in the wound here they include a little security baffle this little steel piece that installs to the frame and covers a part of this turning driveshaft when
this desk sees any lateral movement at all the drive shaft hits this baffle and the sound is absolutely infuriating to top things off I chose to include rolling casters to this desk this was a $30 upgrade and 2 of those four casters got here damaged too my plan for this desk at this point is to lose the desk top and came with completely and replace it with a white laminate lemon table from Ikea and use it as an adjustable photo table which you can’t do this frame will accommodate desktops up to 63 inches large and 31 and a half inches deep so this will roll around the studio make it simpler to film items without needing to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift first that is a financial investment in quality workplace furnishings that will last you this at best feels like a cheaper imitation of that it simply does not feel quality and the difference in between this desk and my main desk is night and day do do not hesitate to check out their website also which also feels eerily comparable to one of their competitors there’s a wealth of accessories you can get for the flexi spot desk approximately and consisting of a foot massager and even a fixed exercise bike and I might spend another 10 minutes of our valuable time covering different options and devices I could but I believe I’m happier that they just sent a basic desk due to the fact that as a fundamental desk I’m not a fan of the quality assurance at this rate point and I do not think slapping on a bunch of extras is the move when the core product isn’t what it ought to be they do use a 30-day trial if you’re simply morbidly curious and they warranty their desks for three years very desk is five years and uplift desk is 7 years if you are Flexispot Standing Desk Pro Review
in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in regards to gaming and productivity however I would spend the extra money it’s gon na take to enter into a higher end producer like uplift desk or really desk and I haven’t personally utilized very desk items so I can’t speak on it however their reputation is excellent big thanks to flexi area for sending this out for review regrettably I can not suggest this system and for the record I’m a hundred percent sure they would have happily replaced the parts that I had an issue with viewing as how both the desktop and the casters got here harmed but from a consumer perspective you ‘d most likely be actually excited to get this in