Flexispot Standing Desk Review …Flexispot Standing Desk Set Height…
Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are very little, here are a couple of functions that I wasn’t always a big fan of:
The plan that the desk was available in was heavy, so bringing it inside was a group effort, but this is just a consequence of how durable the Flexispot is.
The practical cable tray was a little bit confusing to set up. In the end, you ultimately slip it under screws, which wasn’t very clear from the instructions.
You will need to buy an anti-fatigue mat to remain comfortable, but this is a good idea for any standing desks, so I can’t fault Flexispot for that.
When it got here and I saw how heavy it was, I was both fired up (because this meant it was going to be tough) and also a little reluctant (due to the fact that we all understand just how much of a challenge putting together furnishings can be).
Fortunately, with the help of a training YouTube link, it took me only around 42 minutes to assemble. Scratch that, it took my 11-year-old daughter, with some guidance from me, from start to finish. The only problem I have with assembly was the cable tray, which I discovered wasn’t discussed well in the guidelines.
As soon as put together, I love the sleek appearance of this desk. I’m positive any of the many diverse surfaces that it is available in would look excellent in any office, and the adjustable width makes it simple to fit it in even the smallest of office.
The peaceful operation and height memory settings make it easy, effective, and quiet to switch in between sitting and standing as often times as you desire throughout the day.
Last but not least, this desk is tough. It can hold up to 335 lbs even while in operation, so if you have a hefty desktop computer (or wish to sleep on it for some reason) it has you covered. It will also evenly distribute weight no matter how out of balance the weight you put on it is, it won’t wiggle or wobble.
in that video is pretty kitted out as the desk we’re looking at today is pretty fundamental I attempted to get as near that as I could on uplifts website with similar setups the flexi area desk we’re looking at today will run you about four hundred and 10 dollars versus 6 hundred and fifty for a comparable desk from uplift I try to get as close as possible with the uplift design is really five inches longer but you can do a lot with five inches boom yes now for transparency flexi spot did send this desk out for review but as you need to know by now doesn’t affect my review in any way the desktop here is 55 inches wide 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming however it’s not delivering until the end of April at the earliest the desktop is an inch thick however it’s this basic laminate as you can potentially get lacking even any cable television grommets for travel through the outdoors carton
for the desktop was not damaged in any way which is absolutely unusual due to the fact that I could shoot a 30-second b-roll montage of simply the damage and flaws on this desktop scuffed scraped pitted just super rough guy if I had bought this I ‘d have been on the phone with customer support instantly they did also managed to miss out on drilling the pilot holes where you can attach the control box to the desktop a lot of needing to do that myself without unintentionally drilling through the other side of the desktop so yeah pilot holes in wood screws is how you’re gon na be connecting the surface to the frame that’s a far cry from the embedded metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was in fact pretty simple the entire thing came together in about 45 minutes and despite the fact that there’s cables running to it from each part to support motorized function unusually absolutely where any kind of cable management materials whatsoever the frame on this system is a single motor double stage design versus the double motor three-stage design that comes standard with the uplift desk this can be updated too to both the double phase double motor and a three-stage dual motor which pushes the cost of the desk up
an extra 70 dollars the frame is designed for a max load of 154 pounds and it moves at a rate at an inch per second the height can range from simply under 28 inches to just over forty seven point six inches so a max I ‘d it is more than high adequate even for me and I stay at 6 foot for this design does come basic with the control panel that allows for up-and-down movement plus 3 memory areas with an LED readout to inform you the desk height the single motor style utilizes this drive shaft assembly which has to be adjusted as the width of the desk is adjusted the motor operation itself while it might be sluggish is extremely peaceful as in barely audible this outside a rate would be the one benefit I would provide this system over the uplift desk and I want to be careful here because this isn’t a hit piece this desk is 240 dollars cheaper than the equivalent uplift design over 35% more affordable even if you upgrade this flexi spot test to the dual motor three-stage style it still can be found in a hundred and seventy dollars more affordable than the uplift but more affordable does not indicate cheap this desk is still over four hundred dollars if I had actually paid over $400 for this desk I ‘d have an issue with that the front to back stability of this desk is solid even if max height I’ll certainly offer it that however the lateral stability of this desk the horizontal motion at this price point it’s inappropriate it’s add fuel to the fire here they include a little safety baffle this little steel piece that mounts to the frame and covers a portion of this rotating driveshaft when
this desk sees any lateral movement at all the drive shaft strikes the sound and this baffle is definitely shocking to top things off I decided to add rolling casters to this desk this was a $30 upgrade and two of those 4 casters showed up damaged too my plan for this desk at this moment is to lose the desk top and featured entirely and replace it with a white laminate lemon table from Ikea and utilize it as an adjustable photo table which you can’t do this frame will accommodate desktops up to 63 inches large and 31 and a half inches deep so this will roll around the studio make it easier to movie products without needing to change complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I found uplift initially that is a financial investment in quality office furnishings that will last you this at best seems like a cheaper imitation of that it just doesn’t feel quality and the distinction between this desk and my main desk is night and day do feel free to check out their website as well which also feels strangely comparable to one of their rivals there’s a wealth of accessories you can get for the flexi spot desk approximately and consisting of a foot massager and even a fixed stationary bicycle and I could invest another 10 minutes of our precious time covering numerous alternatives and devices I could however I think I’m better that they just sent a standard desk due to the fact that as a standard desk I’m not a fan of the quality control at this rate point and I don’t believe slapping on a lot of bonus is the relocation when the core product isn’t what it need to be they do provide a 30-day trial if you’re simply morbidly curious and they guarantee their desks for 3 years extremely desk is 5 years and uplift desk is 7 years if you are Flexispot Standing Desk Set Height
in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in terms of gaming and efficiency but I would spend the extra money it’s gon na take to get into a higher end producer like uplift desk or very desk and I have not personally utilized very desk products so I can’t speak on it however their reputation is excellent big thanks to flexi spot for sending this out for review unfortunately I can not suggest this unit and for the record I’m a hundred percent sure they would have happily changed the parts that I had a concern with seeing as how both the desktop and the casters got here damaged but from a consumer perspective you ‘d probably be truly delighted to get this in