Flexispot Standing Desk Review …Flexispot Trustpilot…
Cons: What I Didn’t Like About the Flexispot E7
The cons on this desk are minimal, here are a few features that I wasn’t necessarily a big fan of:
The bundle that the desk came in was heavy, so bringing it inside was a group effort, but this is simply a consequence of how strong the Flexispot is.
The practical cable television tray was a bit confusing to set up. In the end, you ultimately slip it under screws, which wasn’t really clear from the instructions.
You will need to purchase an anti-fatigue mat to remain comfy, however this is an excellent concept for any standing desks, so I can’t fault Flexispot for that.
When it arrived and I saw how heavy it was, I was both fired up (given that this implied it was going to be sturdy) and likewise a little reluctant (due to the fact that we all understand how much of an obstacle assembling furniture can be).
Fortunately, with the help of an instructional YouTube link, it took me just around 42 minutes to assemble. Scratch that, it took my 11-year-old child, with some supervision from me, from start to finish. The only problem I have with assembly was the cable tray, which I discovered wasn’t described well in the guidelines.
As soon as put together, I like the streamlined appearance of this desk. I’m positive any of the many diverse finishes that it can be found in would look terrific in any workplace, and the adjustable width makes it easy to fit it in even the smallest of home offices.
The quiet operation and height memory settings make it easy, effective, and peaceful to switch in between sitting and standing as often times as you desire throughout the day.
This desk is durable. It can hold up to 335 lbs even while in operation, so if you have a large desktop computer (or wish to take a nap on it for some reason) it has you covered. It will also uniformly disperse weight no matter how out of balance the weight you place on it is, it will not wiggle or wobble.
in that video is pretty kitted out as the desk we’re taking a look at today is pretty fundamental I attempted to get as near that as I could on uplifts website with comparable setups the flexi spot desk we’re looking at today will run you about four hundred and 10 dollars versus 6 hundred and fifty for a comparable desk from uplift I try to get as close as possible with the uplift design is in fact five inches longer but you can do a lot with five inches boom yes now for transparency flexi area did send this desk out for review but as you need to understand by now doesn’t affect my review in any way the desktop here is 55 inches large 28 inches deep and comes as a $40 upgrade from the base size of 48 by thirty sixty by thirty is coming however it’s not shipping till the end of April at the earliest the desktop is an inch thick however it’s this standard laminate as you can perhaps get doing not have even any cable television grommets for go through the outside container
for the desktop was not harmed in any way which is absolutely strange due to the fact that I could shoot a 30-second b-roll montage of simply the damage and defects on this desktop scuffed scraped pitted just extremely rough guy if I had bought this I ‘d have been on the phone with customer service immediately they did likewise handled to miss out on drilling the pilot holes where you can attach the control box to the desktop a lot of having to do that myself without accidentally drilling through the opposite of the desktop so yeah pilot holes in wood screws is how you’re gon na be attaching the surface to the frame that’s a far cry from the ingrained metal inserts that we saw on the uplift desk so assembly aside from needing to drill that top was really quite simple the entire thing came together in about 45 minutes and despite the fact that there’s cable televisions going to it from each part to support motorized function unusually definitely where any kind of cable management products whatsoever the frame on this system is a single motor double stage design versus the dual motor three-stage style that comes requirement with the uplift desk this can be updated also to both the double stage dual motor and a three-stage double motor which pushes the cost of the desk up
an additional 70 bucks the frame is created for a max load of 154 pounds and it moves at a rate at an inch per second the height can range from just under 28 inches to simply over forty seven point 6 inches so a max I ‘d it is more than high enough even for me and I stay at 6 foot for this model does come standard with the control panel that enables up-and-down movement plus 3 memory areas with an LED readout to tell you the desk height the single motor design uses this drive shaft assembly which needs to be changed as the width of the desk is adjusted the motor operation itself while it might be sluggish is really quiet as in barely audible this outside a rate would be the one benefit I would provide this unit over the uplift desk and I wish to take care here since this isn’t a hit piece this desk is 240 dollars more affordable than the comparable uplift model over 35% cheaper even if you update this flexi area test to the double motor three-stage design it still comes in a hundred and seventy dollars more affordable than the uplift however cheaper does not suggest low-cost this desk is still over four hundred dollars if I had paid over $400 for this desk I ‘d have a problem with that the front to back stability of this desk is solid even if max height I’ll definitely provide it that however the lateral stability of this desk the horizontal motion at this price point it’s inappropriate it’s rub salt in the wound here they include a little security baffle this little steel piece that installs to the frame and covers a part of this turning driveshaft when
this desk sees any lateral movement at all the drive shaft strikes the noise and this baffle is absolutely infuriating to leading things off I decided to add rolling casters to this desk this was a $30 upgrade and two of those four casters got here harmed too my plan for this desk at this point is to lose the desk top and featured completely and change it with a white laminate lemon table from Ikea and utilize it as an adjustable picture table which you can’t do this frame will accommodate desktops as much as 63 inches large and 31 and a half inches deep so this will roll around the studio make it much easier to film products without needing to adjust complex or heavy slider setups and what I personally pay $400 for that no I lucked out that I discovered uplift initially that is a financial investment in quality workplace furniture that will last you this at finest seems like a more affordable imitation of that it simply doesn’t feel quality and the difference in between this desk and my primary desk is night and day do feel free to have a look at their site as well which also feels eerily comparable to one of their rivals there’s a wealth of accessories you can get for the flexi area desk approximately and including a foot massager and even a fixed exercise bike and I could invest another 10 minutes of our precious time covering various choices and accessories I could but I believe I’m happier that they just sent out a basic desk because as a fundamental desk I’m not a fan of the quality assurance at this price point and I don’t think slapping on a lot of bonus is the relocation when the core product isn’t what it need to be they do offer a 30-day trial if you’re just morbidly curious and they guarantee their desks for three years really desk is five years and uplift desk is seven years if you are Flexispot Trustpilot
in the market for a sit-stand desk they’re amazing mine’s been a life changer for me both in regards to video gaming and productivity but I would invest the extra money it’s gon na require to get into a greater end maker like uplift desk or extremely desk and I haven’t personally utilized really desk products so I can’t speak on it but their credibility is excellent huge thanks to flexi spot for sending this out for review regrettably I can not suggest this unit and for the record I’m a hundred percent sure they would have happily changed the parts that I had an issue with seeing as how both the desktop and the casters arrived harmed however from a consumer perspective you ‘d probably be truly delighted to get this in